1. When starting up, only one person can operate it. When the machine starts, there will be an alarm, and all personnel should be in a safe position at this time.
2. Before pushing the upper and lower plates into the machine, it is necessary to check for any foreign objects and ensure that the plate screws are tightened. Push the board gently to avoid damaging the machine.
3. When pulling up and down, the pulley and locking pin must be in place to prevent falling and injuring personnel.
4. When adjusting the side and back alignment, simply push the paper. Do not allow too much thrust to avoid damaging the components.
5. When stopping for a long time, the upper and lower plates must be pulled out of the machine and the lower platform must be stopped at the lowest position.
6. Run the machine for 3 to 5 minutes before normal startup, and check whether the oil pressure and air pressure are normal.
7. Before inserting the turning crank, be sure to wait until the flywheel completely stops rotating. When manually turning, the turning personnel should stand on the side of the turning handle. The turning direction should be reverse.
8. When raising the paper receiving table, it is important to concentrate highly to prevent the paper stack on the paper stool or paper stool from colliding with the paper leveler and damaging other components, such as the teeth. When raising the paper feeding table, it is necessary to prevent the paper stack stool from exceeding the limit and hitting the Feida head.
9. When lowering the paper feeding and receiving tables, prevent feet from being crushed.
10. When extracting samples, pay attention to your gestures to prevent your hands from being raised too high and being injured by your teeth.
11. When hot stamping, it should be noted that when the first (last) sheet is hot stamped, the machine will pause the alarm and start self increasing (decreasing) pressure. After increasing (decreasing) pressure, it will continue to operate. When pausing, operators should pay attention to their safety.
12. When the paper receiving rack is not stopped, be careful not to take too long because the paper receiving rack does not automatically lower without stopping. Excessive paper thickness can cause the machine to automatically stop or damage the machine.
13. When entering the machine for operation, it is necessary to first stop the lower level motor at the lowest position and stop the main motor. Only after the flywheel is completely stationary can maintenance or installation of aluminum carbide be carried out, otherwise it is unsafe.